Installation Guide

Page 6
Wiring - Installing the Harness & Jumper
Page 5
6. Unplug the
headlight connector
from the back
of the headlight.
Plug the supplied
Clearwater Lights
headlight jumper
into the back of
the headlight. Plug
the OEM headlight
connector into the
Clearwater Lights
jumper. The jumper
acts as a pass
through.
5. We recommend
the Clearwater
Lights harness
be installed and
fastened towards
the front of the bike
under the front
faring. Use the
supplied zip ties to
secure in place.
7. The white wire that comes off of the headlight
jumper is the highbeam signal wire. The red wire from
the headlight jumper is the switched hot signal wire.
These wires should be Posi-Locked to their matching
thin colored wires on the harness. The second white
wire from the harness is for the optional horn feature
which will turn the Clearwater Lights to 100% when
the horn is pressed. Use the supplied Posi-Tap to tap
into the 12V+ horn wire.
Reference the wiring diagram on page 3 for a visual
representation of these instructions and for the
system’s overview.