Installation Guide

Page 3
Step 1: Parts List and Bike Preparation
About Our Lights, General Tips
Page 2
Installation Tips:
There are two main parts to the installation of
your new Clearwater Lights. The mechanical portion,
and the electrical portion. With this manual, we will
go over the basics of both which should allow you to
get your lights up and running. For more information
please visit our website at:
www.clearwaterlights.com
Note: Motorcycle engine needs to be running before
the lights will function.
Erica / Krista / Sevina Technical:
Clearwater Lights are very bright LED auxiliary
lights. Do not use these with oncoming traffic present
unless the dimmer is turned down all the way. Krista,
Erica and Sevina are designed as off road only light’s
due to the powerful light output and specific beam
pattern they boast. The wide circular pattern is very
useful on mountain roads when on a motorcycle, as
it keeps light on the road and in the tree canopy. As
the bike leans, lights are still focused on the road. Be
certain to use the lights in a manner that does not
blind oncoming traffic.
Erica / Krista / Sevina can also be used in a “low”
beam mode and a “high” beam mode. The factory
handlebar high beam switch is used to select the two
different Erica / Krista / Sevina modes.
Krista light output is about 3000+ lumens each
light while only using 35 watts of power. Erica light
output is 6000+ lumens each light while using about
60 watts of power. Sevina commands 7000+ lumens
each light using about 70 watts of power. Erica / Krista
/ Sevina are easy to install and have many, many uses.