Installation Guide
Fastener Recommendation
We recommend RSS Rugged Structural Screws by GRK
Fasteners (product image shown). Based on their rated loads
the screw has an allowable steel strength in tension of 1,415lb.
Utilizing a 200lb point load at the top of a 42” glass panel with
2 spigots, the tensile load per fastener (1 per spigot) is 1,333lb.
The GRK RSS 5/16x4 fasteners are strong enough to resist the
applied load.
This product is available at Home Depot:
• Internet #203525067
• Model #112225
• Store SKU #518167
Part Number
CVGR 316 SSOD48-180
Satin Finish
Product Name
Round Deck Mount
Spigot
Spigot Size
1.9” diameter x 7.1” tall
Spigot Weight
5.5 lbs.
Glass Thickness/
Dimensions/Weight
(per panel)
1/2”/ 60” width x 39.37”
height/105 lbs.
Accessories
Included
Base Cover, Rubber
Gasket
Specifications
Helpful Installation Tips
• Mark spigot location on glass panels with a crayon or wax marker. This allows for fast and easier installation of
panel in proper location.
• Some clients have suggested screwing the rim joist to the joist as the screws will hold the rim joist tight to the joist
where as nails may not.
VERY IMPORTANT
•
Apply a bit of lubricant (petrolium jelly) to the inside of the spigot’s black plastic boot where the boot
meets the
glass. The application of lubrication prevents the spigot’s black plastic boot from grabbing the glass panel
should you slide/move the glass to adjust its position while in the spigots.
• Do not attempt to slide the glass panel while it is in the spigot if there is no lubricant on the black plastic spigot
boot as the glass
panel may stick and fail.
• If no lubrication is applied to the spigot boot, you must lift the glass panel out of the spigot, adjust its position
as desired and then lower the glass panel back into the spigot.
“Do Not Slide Glass
Panel while in spigots.
Li the glass panel out
of the spigots to adjust
glass panel position“.
“When glass panel is in
desired position lower
glass panel back into
spigots”.
Also need to add “Spig-
ots must be in perfect
alignment with each
other and fully tighten
down iso they are xed
and will not move prior
to placing glass panel