Installation Guide

ManualsBrandsClearView GLASS RAILINGS ManualsDeck Railing SystemsClearView Glass Railings 60 in. x 39.37 in. Tempered Laminated Hercules Glass Panel with Spigots

Fastener Recommendation

We recommend RSS Rugged Structural Screws by GRK Fasteners

(product image shown).

This product is available at Home Depot:

• Internet #203525067

• Model #112225

• Store SKU #518167

Part Number

CVGR 316 SSOD48-180

Satin Finish

Product Name

Round Deck Mount

Spigot

Spigot Size

1.9” diameter x 7.1” tall

Spigot Weight

5.5 lbs.

Glass Thickness/

Dimensions/Weight

(per panel)

1/2”/ 60” width x 39.37”

height/105 lbs.

Accessories

Included

Base Cover, Rubber

Gasket

Speciﬁcations

Installation Tips

• Mark spigot location on glass panels with a crayon or

wax marker. This allows for fast and easier installation

of panel in proper location.

•

Apply a bit of lubricant (petrolium jelly) to the inside of the spigot’s black plastic boot where the boot

meets the

glass. The application of lubrication prevents the spigot’s black plastic boot from grabbing the glass panel

should you slide/move the glass to adjust its position while in the spigots.

• Do not attempt to slide the glass panel while it is in the spigot if there is no lubricant on the black plastic spigot

boot as the glass

panel may stick and fail.

• If no lubrication is applied to the spigot boot, you must lift the glass panel out of the spigot, adjust its position

as desired and then lower the glass panel back into the spigot.

• VERY IMPORTANT •

GENERAL NOTES:

1. THIS GUARDRAIL SYSTEM IS IN COMPLIANCE WITH THE 2014 AND 2017 INTERNATIONAL BUILDING CODE (IBC) SECTION 1607.8. IT IS ALSO IN

ACCORDANCE WITH 2015 IBC SECTION 2407 THAT REQUIRES ALL-GLASS HANDRAILS AND GUARDS BE “LAMINATED GLASS CONSTRUCTED OF

FULLY TEMPERED OR HEAT-TREATED GLASS”. 2. CONNECTION TO DECK SHOWN (4) 3/8” LAG BOLTS THROUGH DECK TO (3) 2X10 BOARDS, MEETS

IBC DECK REQUIREMENTS FOR A 200 POUND POINT LOAD OR 50 POUND LINE LOAD AT ANY PLACE ON PANEL. LOADING TO BE EITHER VERTICAL

OR HORIZONTAL BUT NOT SIMULTANEOUS. 3. WHEN THREE SPIGOTS ARE USED, THIS PRODUCT COMPLIES WITH THE REQUIREMENTS

FOR HIGH

VELOCITY HURRICANE ZONES (HVHZ). 4. SPIGOTS TO BE 316 STAINLESS STEEL. 5. CONNECTION TO BUILDING VARIES BY PROJECT,

TO BE DESIGNED

BY PROJECT ENGINEER.

6. THE ABILITY OF THE EXISTING HOST STRUCTURE TO SAFELY SUPPORT THE LOADS SHALL BE DETERMINED BY THE

PROJECT ENGINEER. 7. MECHANICAL FASTENERS, AS SHOWN.