Owner`s manual

99
Settings
1 MIDI Channel
The MIDI Channel setting allows the transmit/receive channel to be specied. The selected channel will function as
both the transmit and receive channel (separate transmit/receive channels cannot be specied).
1. Selecting the MIDI Channel setting
After entering the MIDI Settings menu (page 98):
Press the d or
c
buttons to select the MIDI Channel setting.
2. Changing the MIDI Channel value
Press the e or f buttons to increase or decrease the value of
the MIDI Channel setting.
* The MIDI Channel value can be adjusted within the range of 1 - 16.
* To reset the MIDI Channel setting to the default value, press the
FUNCTION button (RESET).
* Any changes made to the MIDI Channel setting will remain until the
power is turned o.
* Preferred MIDI Channel settings can be stored to a Registration
memory for convenient recall. Please refer to page 30 for more
information.
3. Exiting the MIDI Channel setting
Press the FUNCTION button (BACK) to exit the MIDI Channel
setting and return to the Function Menus screen.
 Omni mode
When the CS10 digital piano is turned on, the instrument is automatically set to ‘omni mode on’, allowing MIDI information to be
received on all MIDI channels (1-16). When the MIDI Channel setting is used to specify a transmit/receive channel, the instrument
will be set to ‘omni mode o’.

Multi-timbral mode and Split/Dual modes
Using Split mode with Multi-timbral mode enabled
Notes played in the lower section of the keyboard will be
transmitted on the channel that is 1 channel higher than the
specied channel. For example, if the MIDI channel is set to
3, notes played in the lower section of the keyboard will be
transmitted on channel 4.
Using Dual mode with Multi-timbral mode enabled
Notes played will be transmitted on two channels: the
specied channel and the channel that is 1 channel higher.
For example, if the MIDI channel is set to 3, notes played on
the keyboard will be transmitted on channels 3 and 4.
* If the specied MIDI channel is 16, the lower section / layered part will be transmitted on channel 1.