Owner`s manual
119
Appendix
Jack Panel
LINE IN jacks (1/4” phone jack)
These jacks are used to connect a pair of stereo outputs from
other electronic instruments or audio equipment to the CS10
digital piano’s speakers. The input level signal from these jacks
can be adjusted using the LEVEL knob, or by adjusting the
volume of the connected device.
To connect a device in mono, connect the cable to the L/MONO
jack only. The CS10 digital piano also allows the LINE IN audio to
be mixed with a recorded MP3/WAV le.
* The ‘Line In Level’ setting can also be used to adjust the level of the
LINE IN signal. Please refer to page 67 for more information.
USBtoHostport(‘B’type)
This USB port is used to connect the CS10 digital piano to a
computer using an inexpensive USB cable. When connected, the
instrument can be used as a standard MIDI device, allowing it to
send a receive MIDI data. Connect a ‘B’ type USB connector to
the instrument, and an ‘A’ type USB connector to the computer.
* Please refer to page 105 for more information about USB MIDI.
LINEOUTjacks(1/4”phonejack)
These jacks are used to connect the stereo output of the CS10
digital piano’s sound to external speakers, ampliers, mixers,
recording devices, and similar equipment.
Mono signals will be output only if a cable is connected to the
L/MONO jack.
The MASTER VOLUME knob does not aect the LINE OUT level.
* The ‘Line Out Volume’ setting can be used to adjust the level of the
LINE OUT signal. Please refer to page 68 for more information.
MIDI IN/OUT jacks
These jacks are used to connect the CS10 digital piano to external
MIDI devices, and also to a computer with a MIDI interface as an
alternative to the ‘USB to Host’ port.
* Please refer to page 97 for more information about MIDI.
Headphone Panel
PHONES jacks (1/4” phone jack)
These jacks are used to connect stereo headphones to the CS10
digital piano. Two pairs of headphones can be connected and
used simultaneously. When a pair of headphones is connected,
sound will not be produced by the speakers.
USBtoDeviceport(‘A’type)
This USB port is used to connect a USB memory device to the
CS10 digital piano. This allows MP3/WAV audio les, and SMF
song les to be played directly. It is also possible to record
performances to MP3/WAV audio les, and save recorder songs
stored in internal memory for posterity.
USB device information
It may be necessary to format the USB memory device before
it can be used with the CS10 digital piano. If so, please refer to
the USB Format function instructions on page 116. Formatting
the device will erase all data.
Avoid removing the USB memory device while data is being
loaded or saved, les are being renamed or deleted, or the
device is being formatted.
Other USB devices, such as computer mice, keyboards, or
battery chargers etc. cannot be used with this instrument.
The ‘USB to Device’ functionality of the CS10 digital piano
conforms to USB2.0 Hi-Speed standards. Older USB devices
can still be used, however data transfer speed will be limited
to the maximum transfer speed of the device.
The ‘USB to Device’ port is intended for connecting USB
memory devices, however USB oppy drive devices can also
be used to save recorder songs stored in internal memory, or
play SMF song les.