User's Manual

4
WALL INSTALLATION
The phone can be mounted to any wall surface using two self-tapping
screws (not supplied). Follow the instructions.
1. Install the two self-tapping screws at a distance of 80mm from each
other and located on a vertical centre line (See Figure 1).
2. Slide the handset hanger tab out and reverse its position (rotate it
180 degrees). Slide it back into place so that the hook points up. This
will keep the handset from falling out of the cradle when it is mounted
on the wall (See Figure 2).
3. Holding the phone slightly above the mounting screws on the wall
jack, push the phone against the mounting screws so they are hooked
into upper and lower key hole slots on the bottom of the phone.
4. Slowly slide the phone down until it snaps into place (See Figure 3).
Wall Mounting View
Figure 1
Mounting
pins
Desk use position
Wall mounting
use position
8.0cm
Figure 3
21
If the incoming call number is of 10 or 11 digits, when you press or
button to review it, you can press button to switch this number
between 10 digits and 11 digits. For example, if the number is
1234567890, press button to change it to 11234567890. Or if the
number is 11234567890, press button to change it to 1234567890.
s
t #
#
#
Figure 2