User's Manual

10
15
NOTE:
A. To ask for help by one-touch operation
SOS
SET SOS DIAL
SOS NUMBER DIAL
DELETE
DIAL
SET SOS DIAL
SOS SOUND DIAL
a. To record the SOS message
RECORD SOUND
DIAL
Accessing the SOS function, you can ask for help by one-touch
operation when you are in emergency or pay attention to everything
happens at home by remote control whenever.
You need to connect the adapter for the SOS function.
To use the function of asking for help by one-touch operation, you
need to preset the SOS number and you'd better record the message
you want to tell the helper.
The remote control unit is already registered to the base. When you
cannot use the remote control to dial SOS numbers, do the following
operations.
Press the Remote register button located on the bottom of the base,
then press the button on the remote control unit.
When the LCD shows the menu, press the button to
confirm. Then select the menu and press the
button to enter. There are 6 SOS number available for setting.
a. Press the or button to select one location and enter the
telephone number by keypad (18 digits maximum for each memory).
You can press the button to delete the previous digit.
b. After setting the numbers, press the button to store it and
return to the previous menu.
When the LCD shows the menu, press the button to
confirm. Then select the menu and press the
button to enter.
Press the or button to select menu and press
the button to confirm. You can record a message in 10 seconds.
1. To register the remote control
2. To preset the SOS number
3. To set the SOS message
st
st
SET SOS
10. Delete a single or all record number(s)
11. Earphone using
12.
Find out the number which you want to remove, press button,
the LCD will show and then press button again to
remove this number. If you press and hold button for about 6
seconds, the LCD will show then press the button to
remove all numbers and the LCD will show .
In the state of on-hook,
* Press the or button to select the Caller ID numbers.
* Press the button then press the or button to select the
last dialled numbers.
Plug the earphone into
the socket, then earphone will be activated. In the state, the phone
still works meanwhile you can hear the caller through the earphone.
During a call, to activate the earphone, press
the button then replace the handset in the cradle or press the
button. In the state, you can hear the caller, also you can
answer the caller through the earphone. To switch back, just press
the button or pick up the handset or press the button.
You must insert the adapter for the earphone using.
You can adjust the sending volume by using the Speech volume
control located on the right side of your phone. If your voice is faint or
weak, adjust the volume to "HI . You can also decrease the volume as
well. There are 3 levels available LO ( ), NORMAL ( ) and HI ( ) .
If you adjust the sending volume to "HI" when an adapter is
connected, the receiver volume will decrease 12 dB compared to the
receiver volume you acquire by adjusting the control to "LO" position.
DELETE
DEL ? DELETE
DELETE
ALL DEL ? DELETE
NO CALL
DIAL
NOTE:
"
NOTE:
st
st
Using the AUDIO NECKLOOP socket -
Using the socket-
SPEAKER
SPEAKER
Speech volume control