User's Manual

8
17
B. To take attention to everything happens at home by remote
control whenever
SET SOS DIAL
Auto turn on DIAL
ON/OFF ON
SET SOS DIAL
Pin code DIAL
DIAL
NOTE:
To have the function, you need to turn on the "Auto turn on " and
remember the Pin code.
When the LCD shows the menu, press the button to
confirm. Then select the menu and press the
button to enter. The LCD shows . Then select to turn on
the "Auto turn on " function.
When the LCD shows the menu, press the button to
confirm. Then select the menu and press the button
to enter. Enter the Pin code (up to 4 digits, and the default Pin code is
1234), then press button to confirm.
After turn on " Auto turn on " and set the Pin code, you can use the
function as follows.
After 10 times ringing is detected, the phone will be auto off-hook
the line (In this state, the user can hear the caller but cannot answer
the caller), and then generates two "bip-bip" tones to remind the
caller to enter Pin code to enter full speaker state. The caller enters
the Pin code, and then starts the conversation. Every about 2 minutes
later, the caller will hear two "bip-bip" tones. Press special buttons
(0 9,*,#) to continue the conversation. Otherwise, the line will be
disconnect automatically.
When the phone is auto off-hook the line, the receiver can
press the button to enter full speaker state with caller. In
this way, there is no need for caller to enter Pin code.
1. To turn on " Auto turn on "
2. To set Pin code
~
SPEAKER
BASIC FUNCTION
1. Redial function
2. Flash function
5. Receiver volume and tone select switch
a. Lift handset or press the button to get a dial tone.
b. Press the button to redial the last number called.
You can adjust the receiver volume by sliding the control.
Also you can amplify the receiver volume and tone frequency
according to your own hearing requirements.
The unit must be connected to adapter for the receiver volume
and tone adjustment.
SPEAKER
REDIAL
SPEAKER
VOLUME
Please see the
Amplify Feature part of the manual for details.
NOTE:
This feature allows you to redial the last number you have called by
one-touch operation.
Press the button to terminate a call and institute a
dialling tone for another call or to get another call from "Call Waiting"
(a special telephone service).
If you do not have any special telephone service, such as Call
Waiting, press the button during a call may disconnect
your current conversation.
To switch your call to speakerphone, press the button and
replace the handset in the cradle. To switch back, simply pick up the
handset. In the speaker state, you can make or answer a call.
To adjust the speaker volume, move the switch located on
the right side of the unit to the desired position.
CALL WAITING
NOTE:
CALL WAITING
VOLUME
""
3. Speaker function
4. Speaker volume adjustment