User's Manual

BUEFORE SING
11
BFASIC UNCTION
16
Out of range warning
Line transfer
Paging
In talk mode, if the handset is too far away from base unit, an out of
range warning tone will be heard. The user should move closer to the
base unit. If not, the handset will automatically return to standby mode
after about 20 seconds. When the handset makes a noise, press but-
ton to return to standby mode.
If extra handsets are set to the base unit:
1. During a phone conversation, press button and handset number.
The line will be hold and make music sounds to the other end, both the
two handsets will ring.
2. The other handset can press button to answer the call
automatically after receiving the transfer ring.
3. Press button to cancel the transfer if the other handset user does
not want to answer the call during the transfer ring.
4. If the two handsets do not respond within 40 seconds, the line will be
disconnected automatically.
1. Press the button to page the handset.
2. Press button once more to cancel the paging operation.
3. If you do not press button again, the handset will ring for about
25 seconds then end the paging automatically.
SEL
Handset registration
Settings
1. Make sure the base unit is connected into the AC outlet and line
jack.
2. Press and hold the button on the base unit. After 3 seconds,
press the button on the handset, the unit will give you a
confirmation beep, which means that the code has been set and the
handset will show on the LCD.
3. If you have a second handset need to be registered to the same
base, press the button on the handset until you get a beep and
the display shows . Continue the same procedure, if you have a
third handset. If not, release the button from the base unit.
The button on the base unit should be kept pressing
during the whole procedure.
The base unit and the handset have been set
code already.
In standby mode, press button once, then the LCD will show
to indicate you enter the setting mode.
CH
CH
NOTE:
IMPORTANT NOTICE:
SEL
HS -1
HS -2
PROGRAM
Handset Settings