Programming instructions

ManualsBrandsClearOne ManualsMicrophones and systemsWS800

Receiver Module:

Made In USA

POWER

PHONES

USB

1. Antenna Front Mounting Hole: Use back-to-front TNC cables included.

2. Receiver Module. See details below

3. Mixed audio volume control.

4. USB Port. Connect to computer for ClearOne Remote control. Run software to monitor/edit system

parameters, scan for RF interference and download firmware upgrades.

5. Mixed audio output, 1/4” (See headphone mode - Pg. 3) phone jack for monitoring individual channels

or mixed channels.

6. Power Switch.

ClearOne receiver main-frames hold either four or eight, independent, 24-bit digital audio receiver modules.

There is a front-panel mixed audio output for headphones or direct recording. Each module shares the main-

frame’s two antennas for full-diversity. Up to eight receiver main-frames can be daisy-chained together into an

antenna network that shares two antennas. This eliminates the need for external antenna distribution amps.

Main-frames can be connected to form an Ethernet network that monitor and control the system via a computer.

Main-frames also have USB and RS232 connections for serial monitor and control.

1. Select Next Function: Move the cursor to the next menu function on the display

(Under construction)

2. IR Sync LED: Sends IR information to SYNC the receiver and transmitter (SYNC pg4)

3. Select Previous Function: Move the cursor to the previous menu function (Under

construction)

4. Soft Key Left: Select the choice displayed in the bottom left of the display 4 & 6

pressed at the same time: Sends SYNC signal from receiver to transmitter (SYNC pg4)

5. Status LED:

• Green --> The channel is ON and un-muted

• Red --> The channel is OFF

• Flashing Red --> Encryption key mismatch, Re-sync receiver with transmitter

• Amber --> The receiver is muted or GPIO is triggered

6. Soft Key Right: Select the choice displayed in the bottom right of the display

Modules are designed for quick and easy

field replacement for added redundancy.

STAT U S

SELECT

FUNCTION

(SYNC)

FRONT PANNEL:

BATTERY

AUDIO

SLOT 3

CH 1

AES256

RF BARS

AUDIO LEVEL

BATTERY LEVEL

CHANNEL NAME

ENCRYPTION

STATUS:

ON = Green

OFF = Red

MUTE = Amber

KEY = Flashing Red (“KEY” = mismatched encryption key)

MODULE:

FREQUENCY

ANTENNA DIVERISITY

(Colored text indicates status)

3 4

5 6

2 31

Receiver: