User Manual

Chapter 5: Services Described 27

SI x t h re S P o N S e

#@TL3800538001161007532_1~UDP10.15.0.11_2141:Room 2 Player#MENU_RESP

NOTE f : itemnum=”-1”. The “-“ sign indicates that there are no more audio sources.

If itemnum = a positive number, then there are more audio sources assigned to this Service

and the command needs to be re-issued until itemnum=”-x” is received.

Example: #@Room 2 Player:~UDP10.15.0.11_5000#MENU_LIST 7,9,SOURCES will get a response

detailing the seventh through ninth items from the MENU_LIST.

NOTE f : If there are only five items in the menu (as in this case), then a command requesting

a list of ten sources, like:

#@Room 2 Player:~UDP10.15.0.11_5000#MENU_LIST 1,10,SOURCES

will still generate the exact same response as above, with the sixth response showing

“itemnum=-1”.

Co m m a N d : #meNu_Sel {{path}}

Selects the Audio Sources from a list available to the Renderer Service.

Example: #@Room 2 Player:~UDP10.15.0.11_5000#MENU_SEL {{sources>Stream 2}}

This command selects Stream 2 as the source to be rendered.

NOTE f : The menu path for this list is established by concatenating the item’s idpath and source id

separated by the “>” symbol.

Example: {{sources>Stream 2}} becomes the menu path to select the fifth (itemnum=5) audio source

based on the responses received from the MENU_LIST example above.

NOTE f : Alternatively, in this specific case, an #SRC_SEL command (see below) may be

used.

Co m m a N d : #multIaudIo

This command causes the renderer service to join an AV super-zone referred to as a “multi-zone session”.

(see section: AV Multi-Zone Operation)

Co m m a N d : #multIaudIo JoIN {{S e S S I o N Na m e }}

sessionName is the name of the multi-zone session. This name may be any string which would be a valid

StreamNet group address name; but it should not be an existing group name because a new group will be

formed using this name. Using an existing group name would have the effect of making the existing group

members part of the multi-zone session and vice versa.

When the addressed renderers receive a JOIN command they will automatically leave any currently active

session to join the new session. Also if the renderer is in the active=”0” state then it will change to the ac-

tive=”1” state before joining the session.

Co m m a N d : #multIaudIo leave

When the addressed renderers receive a LEAVE command they will immediately leave any currently active

session.