User Manual

Editing Devices
5-15
All specifications subject to change without notification. All rights reserved. Copyright © 2008 NetStreams
Main +1 512.977-9393 / fax [phone] / Toll Free Technical Support [phone]
3600 W. Parmer Lane, Suite 100; Austin, TX 78727 / www.netstreams.com.
Figure 5-13 ViewLinX Audio/Video tab
Refer to Table 5-8 for a description of the fields on the Audio/Video tab.
3. Select the Display tab.
The Display tab appears as shown in Figure 5-14.
Table 5-8
ViewLinX Audio/Video Tab
Tab Selection Description
Audio/Video Room Name Name of room that the ViewLinX is in.
Video Output The type of video output from the ViewLinX: Component,
Component SD Only, Composite, S-Video, VGA, or Wide
XGA or Auto Select (VL9100-CS only). Auto Select causes
the ViewLinX to detect the source signal and output to the
appropriate physical connector on the ViewLinX. Auto
Select also provides the option of running a macro based on
whether the source is component or VGA. This is intended
to switch the display input to the appropriate selection.
Video Delay Factor The total video processing delay of the display.
Enable Front IR Receiver Check or uncheck to enable the IR receiver on the front of
the ViewLinX.
Firmware Version The version of firmware.
Device Name The name of the device.
Television Driver The type of driver file for the television.
A/V Receiver Driver The type of driver file for the A/V receiver.
Who Should Handle Volume? Choose from Television Driver, A/V Receiver Driver, or
Neither.