Specifications

Chapter 3: User Options 31
PROGRAMMING OPTIONS
To allow for individual preferences and enhance ease of use, the following features can be programmed:
DHCP, host IP, subnet mask, default gateway IP address, ringer melody, VLAN on/off, help line number, and
AGC/ALC. You can also restore factory defaults.
TO CHANGE DYNAMIC HOST CONFIGURATION PROTOCOL (DHCP)
1. Press and hold the
REDIAL/PROG
key until the Program icon appears on the LCD screen (see figure 3.1).
2. Press
1
to enter the DHCP menu. There are two options: 1 - enable DHCP; and 0 - disable DHCP.
3. Press
REDIAL/PROG
. The current DHCP setting flashes.
4. Press keys
1 oor 00
to enable or disable DHCP.
5. Press
REDIAL/PROG
to save the selection; a confirmation tone plays. Press
CLEAR
to exit programming.
The phone reboots.
TO CHANGE HOST IP ADDRESS
1. Press and hold the
REDIAL/PROG
key until the Program icon appears on the LCD screen (see figure 3.1).
>
Note:
DHCP must be disabled in order to change the host IP address manually.
2. Press
2
to enter the Host IP Address menu. The current host IP address is
displayed.
3. Press
REDIAL/PROG
. The current host IP address flashes.
4. Press and hold
CLEAR
to erase the current host IP address.
5. Using the number keys, enter the desired host IP address.
6. Press
REDIAL/PROG
to save the selection; a confirmation tone plays. Press
CLEAR
to exit programming.
The phone reboots.
CHAPTER 3: USER OPTIONS
FIGURE 3.1 MAX IP LCD Program icon