Specifications

Technical or Setup Assistance
Telephone: [phone] (USA) or 801.975.7200 (worldwide) • http://www.gentner.com
Audio Perfect
TM
10 Installation and Operations Manual Page 19
AA
This command activates and deactivates the auto-answer feature.
O <DEVICE> AA <X>
Explanation
<X> is the action (i.e. auto-answer enable, auto-answer diasable, current state)
X=0 Parameter disables auto-answer
X=1 Parameter enables auto-answer
X=2 Parameter to toggle the state from one state to the other (regardless of current state)
X= Null Parameter to report back the current state.
DIP SWITCH 4 NOTE:
This serial command only functions if dip switch 4 is OFF (DOWN).
DIAL
DTMF tones can be generated through the AP10. This capability remains active after a call is placed, so tones can be
issued for use with voice mail and pagers.
CONNECTION NOTE:
If the AP10 is not connected when this command is issued, the unit will connect to the line first, then dial the tone(s).
O <DEVICE> DIAL <STRING>
Explanation
<STRING> is any valid combination of touch tone characters. A comma indicates a two-second pause. STRING has a
maximum length of XX characters. Valid characters are: 0 through 9, A,B,C,D, #, * and ,
Return Values
DIAL returns the dialed string of numbers. The string is returned after the command has been completed (i.e. dialed all
the touch tones).
Example
The following command dials the number [phone].
A 9 and a pause is generated to get an outside line on a PBX.
The number is to be dialed on device #20. The following is returned out the serial port:
#20 DIAL 9,8019757200 #20 DIAL 9,8019757200
HOOK
This command sends a momentary interruption in line seizure (hook flash) to the telephone line. This command is write
only.
O <DEVICE> HOOK
Return Values
If hook flash succeeded, the following is returned out the serial port:
<DEVICE> HOOK
Example
The following command request hook flash from device 20: The following is returned out the serial port:
#20 hook #20 hook