Quick-Start Guide BMA 360 QSG-0086-001 v1.
BMA 360 Quick-Start Guide Contents Important Safety Information ................................................................................. 3 Introduction ............................................................................................................ 4 Operating and System Requirements ................................................................... 6 Setup .......................................................................................................................
Quick-Start Guide BMA 360 Important Safety Information 1. Read and follow all instructions. 2. Keep these instructions. 3. Do not use these devices near water. 4. Clean only with dry cloth. 5. Do not block any ventilation openings. Install in accordance with manufacturer instructions. 6. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 7.
BMA 360 Quick-Start Guide Introduction The patented BMA 360 is the world’s most technologically advanced ceiling tile beamforming mic array, delivering unrivaled audio performance and deployment ease. The world’s first truly wideband, frequency invariant beamforming mic array with uniform gain response across all frequency bands. FiBeam™ technology gives users the ultimate in natural and full fidelity audio across all beams and within a single beam.
Quick-Start Guide BMA 360 System Diagram Three daisy-chained BMA 360 microphone arrays, with 2x30W and 4x15W speaker configurations, connected to a CONVERGE Pro 2.
Quick-Start Guide BMA 360 Operating and System Requirements System Power and Thermal • Power Source: PoE injector • 55W at 1/3 power x 4 @ 1kHz • Power Consumption: • Thermal: 270 BTU/hr at max power • 100-240VAC, 50/60 Hz • • 23 Watt typical without speaker amp Operating Temperature: 14 °F/-10 °C to 104 °F/40 °C ambient temperature.
Quick-Start Guide BMA 360 Install the BMA 360 with Seismic Cables You can mount the BMA 360 in a suspended ceiling, held in place by the standard t-bar grid, with additional 1/8” diameter seismic cables (not included). For safety, ClearOne recommends attachment at the four points shown. Step 3: Connect the BMA 360 a. Description of Controls and Connection Warning: • Power over Ethernet (PoE) equipment used with a BMA 360 must meet the IEEE 802.3af, 802.3at or 802.3bt standards.
Quick-Start Guide BMA 360 CONVERGE Pro 2 (CP2) Figure 2. CONVERGE Pro 2 Back Panel Item Description e P-Link Out: RJ45 connector. Connects to the BMA 360. b. Connect the BMA 360 to Your System On the BMA 360 back plane, make the following connections: • If you have not already done so, connect the external speakers to the BMA 360. • With a CAT6 cable, connect the BMA 360 P-Link In connector to the CP2 P-Link Out connector.
Quick-Start Guide BMA 360 Compliance Details about compliance for the BMA 360 are available online on ClearOne’s website (www.clearone.com) in Support & Training > Resource Library. ClearOne Contacts Headquarters Sales 5225 Wiley Post Way Suite 500 Salt Lake City, UT 84116 www.clearone.com Tel: 801.975.7200 e-mail: sales@clearone.com US & Canada Technical Support Tel: 801.975.7200 Fax: 801.303.5711 Tel: 801.974.3760 e-mail: tech.support@clearone.com International Tel: +801.974.
