Installation & Assembly

ManualsBrandsClearMirror ManualsCore PlumbingClearmirror Shower 12 x 12

Shower ClearMirror Fog-free

Shower Mirrors

Models 16101-121224M, 122424M 161624M, 181824M, & Custom

June 2018

Shower ClearMirror

Installation Instructions

IMPORTANT INSTRUCTIONS

Only wire the Shower ClearMirror to the 24-volt plug-in power supply included with this

product. Install in accordance with all applicable safety, national and local electrical codes.

Read all instructions before using the Shower ClearMirror.

Summary of content (6 pages)

PAGE 1
Shower ClearMirror Installation Instructions Shower ClearMirror Fog-free Shower Mirrors Models 16101-121224M, 122424M 161624M, 181824M, & Custom June 2018 IMPORTANT INSTRUCTIONS Only wire the Shower ClearMirror to the 24-volt plug-in power supply included with this product. Install in accordance with all applicable safety, national and local electrical codes. Read all instructions before using the Shower ClearMirror.
PAGE 2
NOTICE: All installation wiring must be performed by a licensed electrician. Follow the National Electrical Code, local codes, NFPA 70-2011 as applicable. NOTICE: Only use the power supply included with this product. NOTICE: All wiring including new receptacles, must be performed by a licensed electrician. Follow the National Electrical Code or local codes as applicable. WARNING: Direct plug-in power supply must be placed in a dry location outside of the shower.
PAGE 3
WARNING: This stage requires a qualified electrician and conformance with both the National Electrical Code and local building codes. Turn off the power to the circuit connected to the light fixture at the disconnect means. Failure to do so could result in death or serious injury. JUNCTION BOX AND WIRING Observe electrical load requirements. Ensure total amperage does not exceed rating of the wall switch (i.e. 15-amp switch), circuit or existing wiring.
PAGE 4
NOTICE: This stage requires two people. One to hold the mirror and another to connect the wires with UL approved wire nuts or snap connectors. DO NOT LET MIRROR HANG FROM CONNECTED WIRES! MOUNTING THE MIRROR 1. Install tile to the edge of your marked mirror location. Account for the grout line width to match your tile design. 2. Connect power supply wire leads to the wire leads on the mirror heater with UL-approved wire connectors. Wrap with electrical tape. 3.
PAGE 5
WARNING: Mirror must be caulked or grouted into the tile or surround complete and flush with tile surface. Back edge of the mirror cannot be exposed to touch. Failure to do so could result in electric shock or injury. FINISHING THE MIRROR Caulk or grout around the edges. See Figure 3. Figure 3. Grout around the mirror to seal and finish.
PAGE 6
MAINTENANCE The Shower ClearMirror requires very little user maintenance: • Be sure the power is turned off and the heating element (mirror surface) is cool prior to performing any of these functions. • Dampen a lint-free cloth and lightly clean the surface. Never use chlorine base, chemical glass cleaners or any abrasive material on the Mirror. Use of those cleaners or chemicals will void all warranties and guarantees. DO NOT SPRAY MIRROR.