Owner manual

Page 9 of 14 P/N G0200157 Rev E, 1.4.12.11.2014
ClearCube Technology, Inc. 3700 W Parmer Lane Austin, TX 78727 [phone] www.clearcube.com
Rack Rails and Mounting, Continued
Install outer
rack rails
The picture and table below shows how to install the assembled outer rack rails in a rack.
Step
Action
1
Adjust the outer rack rails so that the outer
rails fit snugly in the rack.
2
Align the holes on the front of the outer rail
with the holes on the front of the rack and
secure with the screws provided (see A in
the adjacent picture).
3
Align the holes on the rear of the outer rack
rail with the holes on the rack and secure
with the screws provided (see B in the
adjacent picture).
4
Repeat these steps with the other outer rack
rail assembly.
Next step: Install the workstation in a rack.
Installing in
rack
To install an M1020W-Series Engineering Workstation in a rack:
1. While carefully lifting the workstation, slide the inner rail extensions into the front of the outer
rack rails.
2. Push the workstation into the rack until it clicks into the locked position.
Removing from
rack
This picture and table below show how to remove an M1020W-Series Engineering Workstation from
a rack.
1. Press the outer rack rail latch to release the workstation
chassis (the latch is shown in the adjacent picture).
2. Carefully slide the chassis forward off of the outer rack
rails and out of the rack.
A
B