Owner manual
Table Of Contents
Page 13 of 14 P/N G0200157 Rev E, 1.4.12.11.2014
ClearCube Technology, Inc. 3700 W Parmer Lane Austin, TX 78727 (512) 652-3500 www.clearcube.com
Troubleshooting Video Output, Continued
Setting the BIOS
VGA option
(continued)
Step
Action
5
Select PCIe/PCI/PnP Configuration and press the ENTER key.
6
Select VGA Priority and press the ENTER key.
7
Select Offboard and press the ENTER key.
8
Press the F4 key to save your changes and exit. Select Yes and then press ENTER.
NOTE: The connected VGA monitor will show POST messages and pause at an
animated System Initializing message. This is normal operation.
If installed, the workstation boots to the installed operating system.
You can now reconnect cables (see “M1022W cabling” or “M1024W cabling”) and connect to the
workstation from a zero client.
For local management, you can connect a USB keyboard and mouse to the workstation and then
remove the video cable connecting the PCoIP Host Card and the GPU on the rear of the workstation.
Then connect a monitor directly to the GPU.