Owner manual

Page 10 of 14 P/N G0200157 Rev E, 1.4.12.11.2014
ClearCube Technology, Inc. 3700 W Parmer Lane Austin, TX 78727 [phone] www.clearcube.com
Setting up an M1020W-Series Engineering Workstation
M1022W
cabling
This section shows how to connect cables. Numbers in parentheses correspond to labels shown in
“M1022W front panel” and in “M1022W rear ports and connectors” to ease identification.
Step
Action
1
Install the included mounting rails to the server chassis and then install the chassis
in a rack.
2
From the rear of the chassis, use the included video cables to route video from the
PCoIP host card to the GPU. Use the DP to mini-DP cables, DVI to
mini-DP cables, or both, depending on the workstation’s dual- or quad-video
configuration.
NOTE: Host card mini-DP ports are ordered from 1 (rightmost) to 4 (leftmost). Be
sure to use ports as shown below when connecting cables from the host card
to the GPU (using different ports can cause display issues).
 Connect DP to mini-DP cables from the GPU to mini-DP ports 1 and 2
on the host card (see picture below).
 Connect DVI to mini-DP cables from the GPU to mini-DP ports 3 and 4
on the host card (see picture below).
3
Connect an Ethernet cable to the dedicated PCoIP LAN port (20) and connect the
other end to a network router or switch.
4
Optionally, connect one or more Ethernet cables to the LAN ports (14) and (15)
on the rear of the chassis and connect the other end of the cable(s) to a network
router or switch.
5
Optionally, connect one or more Ethernet cables to the Dedicated IPMI port (11)
on the rear of the chassis and connect the other end of the cable to a network router
or switch.
6
From the rear of the chassis, connect the included power cable to the power
connector (21) on the rear of the server, and connect the power cable to a
power outlet.
7
From the front of the chassis, press the power button (7) to power on the server.
Continued on next page
GPU
Host Card