User`s guide

60 • Chassis and Blade Installation R Series Data Center Products User’s Guide, Rev. B
2. Type clearcube as the default password. For example:
Password: clearcube
NOTE: You will not see any letters as you type the password. The result should be:
RMC Configuration
1. IP address: 192.168.1.251
2. Gateway: 192.168.1.1
3. Network: 192.168.1.0
4. Netmask: 255.255.255.0
5. Password: clearcube
6. Exit
3. From the list of options, select
1 to change the IP address. For example:
>1
The result should be:
>1
new ip:
4. Type in the desired new IP address. For example:
>1
new ip: 192.168.1.100 (your desired IP address)
The result should be:
RMC Configuration
1. IP address: 192.168.1.100
2. Gateway: 192.168.1.1
3. Network: 192.168.1.0
4. Netmask: 255.255.255.0
5. Password: clearcube
6. Exit
NOTE: The IP address should be the new one you typed in.
5. Change the Gateway, Network, and Netmask settings, using the same procedure.
For Gateway, use your network’s default gateway setting. For Netmask, use your
network’s subnet mask setting. For Network, use the base network address,
which is typically your subnet mask ANDed with the IP address (also called the
Subnet ID). For example, if your IP address is 192.168.1.154 and your subnet
mask is 255.255.255.0, then if you AND the two addresses together you get a
Network setting of 192.168.1.0.
6. Enter
6 to exit. For example:
>6
The result should be:
>6
Save changes and reboot <y/n>?
7. Enter
y for yes. For example:
>6
Save changes and reboot <y/n>? y