Owner's manual

Page 6 of 6 P/N G0200166 Rev A, 1.0.05.14.2014
ClearCube Technology, Inc. 3700 W Parmer Lane Austin, TX 78727 [phone] www.clearcube.com
Installation, Continued
VESA mounting
(continued)
Attaching the zero client
Step
Action
1
Remove the designated screws from the sides of the zero client as shown in step 1 on
page 4 above.
2
Position the zero client in the bracket as shown in the figure below and hold in place.
Use the included thumb screws to attach the zero client to the bracket.
3
Connect cables (network, video, and power) to the rear of the zero client.
You can now power on the zero client and connect to a remote device. See the zero client Quick Start
Guide for more information.
Additional Information and Support
Additional
information
For information about zero clients, see the zero client Quick Start Guide or PC-over-IP
®
System
User’s Guide on the Support site.
Contacting
Support
Web
UUUwww.clearcube.com/support/
Email
[e-mail]
Toll-free
[phone]
Direct
[phone]