Owner's manual

Page 4 of 6 P/N G0200166 Rev A, 1.0.05.14.2014
ClearCube Technology, Inc. 3700 W Parmer Lane Austin, TX 78727 [phone] www.clearcube.com
Installation, Continued
Under desk
mounting
(continued)
Attaching the zero client
Step
Action
1
Remove the top-most screws from both sides of the zero client, as shown in the
figure below (remove a total of four screws).
2
Connect cables (network, video, and power) to the rear of the zero client.
3
Align the holes in the zero client with the corresponding holes in the bracket as
shown below. Hold in place while using the included thumb screws to attach the zero
client to the bracket.
You can now power on the zero client and connect to a remote device. See the zero client Quick Start
Guide for more information.
Continued on next page