User's Manual
Table Of Contents
- Preface
- Chapter 1: System Description
- Chapter 2: System Interface
- Chapter 3: Preparing for a New Case
- Chapter 4: System Operation
- Chapter 5: System Settings
- Chapter 6: Review Case Data
- Chapter 7: Cleaning and Maintenance
- Chapter 8: Troubleshooting
- Appendix A: Technical Specifications
- SmartSponge® Flex System Dimensions
- Power Requirements
- Environmental Conditions
- SmartSponge Flex Sponges and Towels
- MRI Information
- EMC Considerations
- Guidance and Manufacturer’s Declaration – Emissions
- All Equipment and Systems
- Guidance and Manufacturer’s Declaration – Immunity
- All Equipment and Systems
- Guidance and Manufacturer’s Declaration – Emissions
- Equipment and Systems that are NOT Life-supporting
- Recommended Separation Distances between portable and mobile RF Communications equipment and the ClearCount SmartSponge Flex Model A04
- Equipment and Systems that are NOT Life-supporting
- Device Label
Chapter 5: System Settings - Edit Settings Mode 5-7
•
•
•
•
•
•
Adjust Volume
Press the VOLUME icon from the Edit Settings screen (or anywhere it appears) to adjust the system volume.
This will bring up the Volume screen where the system’s volume can be adjusted from 0 (off) to 10 (loudest).
Press the up arrow to increase the level and the down arrow to decrease it. When finished, press the ACCEPT
button to retain the new level or press the CANCEL button to abandon the change.
The level set on the Volume screen affects all sounds produced by the SmartSponge Flex; this includes system
alerts and warnings.
The default volume level will be set to the value of 7.
Figure 5-6 Volume Screen
Notes
•
The VOLUME icon appears within multiple system modes. Wherever the icon is
present, press it to adjust the volume.
•
If the volume is set too low, system alerts and warnings might become difficult to
notice.
Change value
with up and
down arrows.