User's Manual

Chapter 5: System Settings - Edit Settings Mode 5-5
•
•
•
•
•
•
Adjust Screen Timeout
The system is set to dim the brightness of the display after a set number of hours of inactivity to prevent screen
burn in. If the system is set for 2 hours, an inactivity screen will appear and the display will be dimmed after
2 hours of no activity. Simply touch anywhere on the screen to restore the brightness back to the set level and
remove the inactivity message.
Press the “SCREEN TIMEOUT” button from the Edit Settings mode screen to set the inactivity timeout of the
display. This will bring up the Set Screen Inactivity Timeout screen where the hours of inactivity can be
adjusted from 1 hour up to 10 hours. Press the up and down arrows to adjust the amount of inactive time that
needs to pass before the display dims. When finished, press the ACCEPT button to retain the new time or press
the CANCEL button to abandon any changes.
The default inactivity timeout will be set to 2 hours.
Figure 5-4 Screen Timeout
Change value
with up and
down arrows.
Press anywhere on
the screen to restore
brightness.