User's Manual
Table Of Contents
- Preface
- Chapter 1: System Description
- Chapter 2: System Interface
- Chapter 3: Preparing for a New Case
- Chapter 4: System Operation
- Chapter 5: System Settings
- Chapter 6: Review Case Data
- Chapter 7: Cleaning and Maintenance
- Chapter 8: Troubleshooting
- Appendix A: Technical Specifications
- SmartSponge® Flex System Dimensions
- Power Requirements
- Environmental Conditions
- SmartSponge Flex Sponges and Towels
- MRI Information
- EMC Considerations
- Guidance and Manufacturer’s Declaration – Emissions
- All Equipment and Systems
- Guidance and Manufacturer’s Declaration – Immunity
- All Equipment and Systems
- Guidance and Manufacturer’s Declaration – Emissions
- Equipment and Systems that are NOT Life-supporting
- Recommended Separation Distances between portable and mobile RF Communications equipment and the ClearCount SmartSponge Flex Model A04
- Equipment and Systems that are NOT Life-supporting
- Device Label
5-4
Chapter 5: System Settings
-
Edit Settings Mode
•
•
•
•
•
•
Adjust Screen Brightness
Press the “SCREEN BRIGHTNESS” button from the Edit Settings mode screen to adjust the brightness of the
display. This will bring up the Adjust Screen Brightness screen where the brightness can be adjusted from 2
(dimmest) to 10 (brightest). Press the up arrow to increase the brightness of the screen and the down arrow to
decrease it. When finished press the ACCEPT button to retain the new brightness or press the CANCEL button
to abandon the change.
By default the screen brightness will be set to the value of 8.
Figure 5-3 Adjust Screen Brightness Screen
Change value
with up and
down arrows.