User's Manual

Chapter 4: System Operation 4-25
•
•
•
•
•
•
Figure 4-18 Case Summary Mode Screen
Count Status: This
displays the Status of the
Sponge Counts.
Broken Protocol
Events:
Lists the
time a Broken
Protocol was
accepted and with
what type of
sponge.
Case ID: This is the same case number that
appears in the upper left of the screen. Record
this in the patient’s record.
Start Time: This is the time
that the current case was
started.
End Time: Will show “In
Process” until the case is
ended. Then will show the
time the case was closed
when reviewing case data.
Sponge Counts:
Lists the sponges
used in the case.
Wand Sessions: The
number of times Wand
mode was entered or a
session was reset.
Notifications: Lists any
Alerts or Warnings that
were encountered during
the case and the time
they occurred.
Broken Protocol
Note: Is displayed
if a Broken
Protocol Warning
was accepted.
BACK button: Returns the system to the
mode that Case Summary was entered
from. (Example: if the system was in Count
Out mode and the CASE SUMMARY
button was pressed, pressing the BACK
button from the Case Summary mode will
return the system to Count Out mode.)
END CASE or OVERRIDE button: If the Count Status is
“COUNTS EQUAL” or “VERIFIED BY ADMIN”, then the END
CASE button will be displayed. If the status is “COUNTS NOT
EQUAL” then the OVERRIDE button will be displayed.
Pressing the END CASE button will close the current case, save
the case data, and return the system to Case Selection mode.
Pressing the OVERRIDE button will advance the system to the
OVERRIDE screen where the user is prompted to scan the
Override Card.
Wand Session
Details:
Lists the
time the session
started, how long
it lasted, and if the
SmartTag was
detected.
SCROLL DOWN