User's Manual

4-8 Chapter 4: System Operation
•
•
•
•
•
•
When switching to Count Out mode, an interim System Info screen will appear for 12 seconds requesting that
all sponges be removed from the vicinity of the Count Out Basin to avoid accidentally being counted out before
they are used. All of the antennas are off during this screen. To bypass the 12 second countdown, press the
CONTINUE button to immediately advance to the Count Out screen.
Figure 4-6 System Info Screen
As sponges are discarded into the Count Out Basin, they will appear in the OUT column for that type of sponge
on the Count Out screen. The Count Out screen contains fields identical to the Count In screen which are
updated as sponges are counted out. The illustration below shows the screen after 10 sponges that were scanned
in have been discarded into the Count Out Basin while in Count Out mode. See
Figure 4-7 .
Figure 4-7 Example: Ten 4x4 Sponges Counted Out
OUT: The number of
sponges counted out.
 : Represents the
reconciliation status of the
row. (
X =NO ,  =YES)
MODE: COUNT OUT
must be displayed to
count sponges out.