User's Manual
Table Of Contents
- Preface
- Chapter 1: System Description
- Chapter 2: System Interface
- Chapter 3: Preparing for a New Case
- Chapter 4: System Operation
- Chapter 5: System Settings
- Chapter 6: Review Case Data
- Chapter 7: Cleaning and Maintenance
- Chapter 8: Troubleshooting
- Appendix A: Technical Specifications
- SmartSponge® Flex System Dimensions
- Power Requirements
- Environmental Conditions
- SmartSponge Flex Sponges and Towels
- MRI Information
- EMC Considerations
- Guidance and Manufacturer’s Declaration – Emissions
- All Equipment and Systems
- Guidance and Manufacturer’s Declaration – Immunity
- All Equipment and Systems
- Guidance and Manufacturer’s Declaration – Emissions
- Equipment and Systems that are NOT Life-supporting
- Recommended Separation Distances between portable and mobile RF Communications equipment and the ClearCount SmartSponge Flex Model A04
- Equipment and Systems that are NOT Life-supporting
- Device Label
Chapter 3: Preparing for a New Case 3-3
•
•
•
•
•
•
Boot-Up Sequence
The Splash screen, shown at the top left of Figure 3-2, appears on the display first for a few seconds after
the On/Off switch is set to On.
The Self Diagnostic screen, shown at the bottom right of Figure 3-2, is displayed for about a minute
directly after the Splash screen and shows a Progress Bar that fills in from left to right. The screen shows
the versions of system firmware, device ID, and system time. Functional status is also checked during
this self test and the results are displayed. When complete, the system enters the Case Selection screen.
Figure 3-2 Boot-Up Screens
The Case Selection screen is displayed after the system successfully completes the self diagnostic checks.
Press NEW CASE to begin a new surgical case.
Splash Screen
Diagnostic Screen