User's Manual

2-8 Chapter 2: System Interface - Active-Case Screens
•
•
•
•
•
•
Case Summary Screen
The Case Summary screen is displayed while in Case Summary mode. Case Summary displays information
about the current case and sponge counts at the time Case Summary is entered. Press the CASE SUMMARY
button at the bottom right corner of the screen to enter the Case Summary. From this screen, you can close out
a reconciled case by pressing END CASE or override an unreconciled case with an Override Card by pressing
OVERRIDE. You may also navigate back to the previous mode by pressing the BACK button. All antennas
are off while in the Case Summary.
Refer to page 4-24 for a description of Case Summary.
Figure 2-11 Case Summary Screen
The END CASE button will be presented if the sponge counts are reconciled.
Pressing it ends the case. The
OVERRIDE button will be presented if the counts
are not reconciled. Pressing it brings up the Override screen for scanning an
Override Card and ending a case with unreconciled counts.
The Count Status will display “COUNTS
EQUAL” if all sponges are reconciled. If any
are missing when Case Summary is entered,
“COUNTS NOT EQUAL” will be displayed.