User's Manual
Table Of Contents
- Preface
- Chapter 1: System Description
- Chapter 2: System Interface
- Chapter 3: Preparing for a New Case
- Chapter 4: System Operation
- Chapter 5: System Settings
- Chapter 6: Review Case Data
- Chapter 7: Cleaning and Maintenance
- Chapter 8: Troubleshooting
- Appendix A: Technical Specifications
- SmartSponge® Flex System Dimensions
- Power Requirements
- Environmental Conditions
- SmartSponge Flex Sponges and Towels
- MRI Information
- EMC Considerations
- Guidance and Manufacturer’s Declaration – Emissions
- All Equipment and Systems
- Guidance and Manufacturer’s Declaration – Immunity
- All Equipment and Systems
- Guidance and Manufacturer’s Declaration – Emissions
- Equipment and Systems that are NOT Life-supporting
- Recommended Separation Distances between portable and mobile RF Communications equipment and the ClearCount SmartSponge Flex Model A04
- Equipment and Systems that are NOT Life-supporting
- Device Label
Chapter 2: System Interface - Active-Case Screens 2-5
•
•
•
•
•
•
Active-Case Screens
Active-Case screens are present during a surgical case. They are initiated after pressing the NEW CASE button
from the Case Selection screen.
When in an active surgical case, the current case number is displayed in the upper left corner of the screen and
the current mode is displayed in the upper right corner of the screen.
The
Case Number
follows a format of:
Five navigation buttons are presented at the bottom of the screen that allow you to switch between modes.
These modes are Standby, Count In, Count Out, Wand and Case Summary. Each mode is briefly described
below.
Figure 2-6 Example of an Active Surgical Case Screen
Device ID
XXXX-YY-MM-DD-ZZZ
Year
Month
Day
Case#
Mode of Operation
Case Number
Navigation Buttons