User's Manual
Table Of Contents
- Preface
- Chapter 1: System Description
- Chapter 2: System Interface
- Chapter 3: Preparing for a New Case
- Chapter 4: System Operation
- Chapter 5: System Settings
- Chapter 6: Review Case Data
- Chapter 7: Cleaning and Maintenance
- Chapter 8: Troubleshooting
- Appendix A: Technical Specifications
- SmartSponge® Flex System Dimensions
- Power Requirements
- Environmental Conditions
- SmartSponge Flex Sponges and Towels
- MRI Information
- EMC Considerations
- Guidance and Manufacturer’s Declaration – Emissions
- All Equipment and Systems
- Guidance and Manufacturer’s Declaration – Immunity
- All Equipment and Systems
- Guidance and Manufacturer’s Declaration – Emissions
- Equipment and Systems that are NOT Life-supporting
- Recommended Separation Distances between portable and mobile RF Communications equipment and the ClearCount SmartSponge Flex Model A04
- Equipment and Systems that are NOT Life-supporting
- Device Label
2-2
Chapter 2: System Interface
-
Boot Up Screens
•
•
•
•
•
•
Boot Up Screens
These screens appear for brief periods when the system is powered on.
Splash Screen
The Splash screen is the first thing displayed when the system is powered on. It will appear for a few seconds.
Figure 2-1 Splash Screen
Self Diagnostics Screen
The Self Diagnostics screen follows the Splash screen when the system boots up. The system displays this
screen while key components are checked. Their status is displayed on the screen. The system’s firmware
version and device ID are also displayed on this screen. This screen is displayed for about a minute and the
remaining time is illustrated by the progress bar at the top.
Figure 2-2 Self Diagnostics Screen