Installation Instructions



1.Windscreen and pop filter 4. Battery cover

2.Display 5.Transmission antenna

3.Power switch/Frequency adjustment

1.Connect the receiver to a power outlet through the power adapter provided and turn

on the receiver.

2.Put two alkaline AA batteries into the battery compartment of the microphone. Please

ensure the positive and negative ends are positioned in the correct direction.

3. Power on the handhold microphone. In case of any frequency interference, press set

button can choose different frequency. There are up to eight frequencies to choose from.

4. Please note that it will take a few seconds for the receiver to automatically syndicate

the frequency will changed after set button each pressed





PAGE 1
.Windscreen and pop filter 2.Display 3.Power switch/Frequency adjustment 4. Battery cover 5.Transmission antenna 1.Connect the receiver to a power outlet through the power adapter provided and turn on the receiver. 2.Put two alkaline AA batteries into the battery compartment of the microphone. Please ensure the positive and negative ends are positioned in the correct direction. 3. Power on the handhold microphone. In case of any frequency interference, press set button can choose different frequency.
PAGE 2
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.