User Manual

Page / Seite 6 © clearaudio electronic GmbH, 2022-12
User manual / Bedienungsanleitung
2. Setup
Select cartridge type operation mode:
Set the switches on the bottom panel of the basic V2 chassis as follows:
• MM operation: Buttons ‘gain’ not pressed in (load impedance = 47 kOhm)
• MC operation: Buttons ‘gain’ pressed in (load impedance = 500 Ohm)
Position MM = button not pressed, position MC = button pressed in.
MM Adjustment MC Adjustment
Subsonic-Filter:
Set the switches on the bottom panel of the basic V2 chassis as follows:
• Subsonic lter is on: Both buttons ‘subsonic’ pressed in
• Subsonic lter is o: Both buttons ‘subsonic’ not pressed in
Subsonic o Subsonic on
- Attention -
All switches are duplicated for the left and right channels.
Please make sure that both corresponding switches are always in the same position.
Before switching any settings be sure to shut o the power to the
basic V2 .
Never cover or put anything on top of the basic V2, which could lead to overheating of electronic
parts.
If the unit is not in use for an extended period, switch it o.