Specifications
16
Increasing the height of the directional antenna relative to the
repeater unit helps improve the level of isolation.
Please contact us by email or phone if you continue to have problems.
2. One of the Clear Voice amplier’s LED indicator lights is blinking.
What is the problem?
This may happen if the strength of incoming signals might be very
low on a particular channel and below the unit’s threshold. This might
happen to the Cell or the PCS bands. The units may still work, but if you
are not receiving adequate performance you should adjust the direction
and position of the outdoor antennas.
3. My phone shows full bars, but I am still dropping calls.
This problem usually indicates that the directional antenna is not
positioned correctly. To improve the alignment, use the technique
described in Step 3. You may need to try some dierent locations around
the building in order to nd the location with the best signal.
If you have relatively weak signal outside the building (2 bars or less),
you should use the Pre-Amplier Kit to improve the signal strength. Call
us or visit our website for more information.
4. My phone shows full bars near the Clear Voice repeater. However,
when I move away, the signal strength falls quickly.
This problem usually indicates that the directional antenna is not
positioned correctly. To improve the alignment, use the technique
described in Step 3. You may need to try some dierent locations around
the building in order to acquire a better signal.
If you have relatively weak signal outside the building (2 bars or less),
you should use the Pre-Amplier Kit to improve the signal strength. Call
us or visit our website for more information.
5. I have set up my repeater, but there is no improvement at all on
my cell phone.
Try moving the directional antenna to dierent sides of the building. If
you continue to have problems, please call our technical support line or