User manual

CLEARjet GmbH CX-one
5. CONNECTING ADDITIONAL DEVICES
Warranty exclusion:
The following technical information is for qualified personell only. This should make
integration and connection of the printer mechanism more easy.
This information implies no functional guarantee from CLEARjet GmbH.
CLEARjet GmbH is not responsible for function, quality, safety, CE-conformity and so on, if
additional units are integrated to the printer, or the printer is connected to other units.
All integration steps and modifications, which are not made from CLEARjet GmbH are in
the responsibility of the system integrator.
For connection of additional devices several connectors with controlling signals and power
supply lines are available.
Specifically, this are control lines for chipcard and magnetic card interfaces, serial
interfaces and for automatic card feeders, etc.
The functionality of these modules is varying and therefore the printer firmware must be
adapted to the particular application. As a result controlling signals can be used only with
suitably adapted firmware. For more information, contact your CLEARjet Partner.
6. INTEGRATION OF CHIPREADERS
6.1. Preface
It is frequently necessary to integrate Smart card interfaces to the printer. Therefore we
collected some general information to this subject.
Chip readers with serial (TTL-level) interface and power supply connector can be
connected to the printer. In this case the full functionality of the Chip interface inside the
printer is obtained.
OEM-User Manual page 9 /19