User manual

CLEARjet GmbH CX-one
This illustration shows a typical command sequence for a print cycle:
ESC "1"
(Hex: 1B 31)
ESC "r1"
(Hex: 1B 72 31)
CTRL "Z"
(Hex: 1A)
Card in
Printposition?
Read/Write
encoding module
Print card?
Send print data
Send Formfeed
(Hex: 0C)
Card out?
ESC "3"
(Hex: 1B 33)
CTRL "Z"
(Hex: 1A)
No
Yes
Resets the printer
(Flags, Printerbuffer,
...)
Yello LED on
The printer is waiting
for a card
Get brief status
Check brief status if
card is in
printposition
RF-/Contactchip,
Magnet or barcode
encoding
Delay: min. 100ms
No
Delay: min. 100ms
No
Eject card without
printing
Formfeed starts
printing and ejects
card
Get brief status
Check brief status if
card was taken from
slot
Note: Check flags
"Card has been
printed = 1" and
"Photo sensor front =
0"
Yes
Programmers Manual Page 6 / 53