User manual

CLEARjet GmbH CX-one
3 Special Printer-Modes
The printer detects several error-situations and is automatically switched to the
corresponding error mode.
There are 3 different error types:
3.1 Fatal error
All LEDs are flashing periodically and printer stops working.
In this mode the printer accepts and responds to 4 commands only:
<ESC>r1,<ESC>r2 Hardware Reset
<SUB> Brief Status
<ESC>$E Read ERROR number
3.2 Non fatal error
Error is not indicated, but the command <ESC>$E returns an error number. This kind
of error indicates situations where the printer works well but the last operation was
performed incorrectly (magnet-encoding errors, empty hopper ...)
For more details see the command “ERROR Code”.
3.3 Heat-up mode
Green LED is flashing periodically and the response to the brief status (<SUB>) is
0xFF (all bits are set).
This indicates that the printer is in heat-up mode after booting or powering up.
Wait until heat-up is finished!
3.4 Cleaning Mode
After detecting a CLEARjet Cleaning card the printer automatically performs a
cleaning procedure and the response to the brief status (<SUB>) is 0xFF (all bits are
set).
Wait until heat-up after cleaning procedure is finished.
Programmers Manual Page 48 / 53