User manual

CLEARjet GmbH CX-one
Auto read <ESC>$m[n]
Description
This function allows automatically decoding of the
magstripe of inserted cards.
Activate or deactivate this function with parameter [n]
[n] = 0..... disable auto read
[n] = 1..... enable auto read
Read data are stored in printer memory. To get the data
use the "Read magnetcode" command (<ESC>$Mr..... )
Note: For this command is a special hardware necessary!
Command is active until reset.
ASCII – Code
<ESC>$m[n]
HEX – Code
1B 24 6D [n]
Example
<ESC>$m1
enable auto read function
Auto eject after write <ESC>$w[n]
Description
This function allows automatically ejecting the card after a
writecycle.
Activate this function with parameter [n]
[n] = 0..... disable auto eject after write
[n] = 1..... enable auto eject after write
The command must be sent for each write-instruction. The
card can not be printed.
Note: For this command is a special hardware necessary!
ASCII – Code
<ESC>$w[n]
HEX – Code
1B 24 77 [n]
Example
<ESC>$w1
enable auto eject after write function
Programmers Manual Page 47 / 53