User manual

ManualsBrandsClear jet ManualsComputer equipmentCX-one

CLEARjet GmbH CX-one

Send graphic data <ESC>G[b]{DATA}

Description

This command sends the printer data for one dot line to the

printer. A parameter between 0x01 and 0x30 must be

entered. The parameter must correspond with the number

of data bytes that follow. The maximum print width

depends on the printhead type (see table below). A logic '1'

in <Data> is the equivalent of one printed pixel.

ASCII – Code

<ESC>G[b]{DATA}

HEX – Code

1B 47 [b] {DATA}

Example

<ESC>G sends the graphical data to the printer line by

line. Printing starts in the top right-hand corner of the card

when printing from right to left.

Maximum number of bytes:

DK200-1: max. 48 bytes (printable max. 48 byte)

Note: Graphicdata starts at first

printable byte. (x-position: 02)

DK300-1: max. 82 bytes (printable max. 76 byte)

Note: Graphic data is located at x-

position 00 (edge of card). To reach

the printable area use 6 leading

<Data> bytes.

Combination of Graphics and Text:

Graphics and text may be combined on the same card.

Use the commands <ESC>x and <ESC>y to position both

graphics and text.

End your data with a form feed to start printing procedure.

Printable area

990

Lines

Data

One graphic line

most sign. byte

last sign. byte

MSB

LSB

print direction

6 byte offset

990