User manual

CLEARjet GmbH CX-one

Limit erase area <ESC>e[nnn][mmm]

Description

The erase area is limited to the domain [nnn] to [mmm]

During the next print procedure this limited area will be

erased. The rest of the card will not be affected, the data in

those areas retains unchanged.

[nnn] possible values range from 000 to 990

[mmm] possible values range from 000 to 990

Note: Power down or a printer reset within 5 sec. after

using this command may cause unpredictable results. The

size of the erase area ([mmm] – [nnn]) must not exceed

720.

ASCII – Code

<ESC>e[nnn][mmm]

HEX – Code

1B 65 [nnn][mm]

Example

<ESC>e200300

The eraser operation is only performed within the

designated area.

erased area

direction

990 400 300 200 100 000

Note: The erase area may extend up to 5 mm depending on card material. Printing

area may be shifted up to 2 mm.

Get print area <ESC>%p

Description

This command returns you the actually set print area

in y-direction.

ASCII – Code

<ESC>%p

HEX – Code

1B 25 70

Example

<ESC>%p

Response: 400700

Programmers Manual Page 31 / 53