User manual

CLEARjet GmbH CX-one
2.3.2 Character and font commands
All internal printer-fonts use proportional character spacing. Charactersize of internal
Fonts is different when using 300 dpi printhead.
Select Font3 <ESC>C
Description
Select the small typeface, Font3.
Print height ca. 1.5 mm at 200 dpi printhead
ASCII – Code
<ESC>C
HEX – Code
1B 43
Select Font2 <ESC>D
Description
Select the medium typeface, Font2.
Print height ca. 2,0 mm at 200 dpi printhead
ASCII – Code
<ESC>D
HEX – Code
1B 44
Select Font1 <ESC>E
Description
Select the large typeface, Font 1.
Print height ca. 3.7 mm at 200 dpi printhead
ASCII – Code
<ESC>E
HEX – Code
1B 45
Get Charactersize <ESC>h[n][m]
Description
All internal fonts use proportional character spacing, so the
size of a printed string depends on the used characters.
This command responds to the size of a specified
character from the internal font and helps to calculate the
effective string size.
[n].... Font number (1, 2 or 3)
[m]... specified character
ASCII – Code
<ESC>h[n][m]
HEX – Code
1B 68 [n][m]
Return-Parameter
from printer
Size of specified character:
{aabb}<CR> aa.... height of character (No. of bytes)
bb.... width of char. (No. of Dots)
Example
<ESC>h1a
Response: 0410<CR>
Programmers Manual Page 27 / 53