User manual

CLEARjet GmbH CX-one
00931 Printhead position could not be found
• Photosensor defective or interrupted (clean sensor path)
• Motor for printhead rotation defective
• Mainboard defective
00932 Card jam at printing
• Photosensor defective or interrupted (clean sensor path)
• Motor for printhead rotation defective
• Mainboard defective
• Card path or motor movement blocked (card got stuck)
00991 Error at preheating: No signal-change during preheating
• Temp. Sensor defective
• No erase-roller installed
• A/D converter defective --- Main board or Printhead-controller
board defective
00992 Error at preheating: Out of range signal from temp. Sensor
• No or wrong parameters in EEPROM
• A/D converter defective
• Short circuit at sensor signal
• Missing sensor (brocken wire, disconnected cable)
00993 Heating error: Controlling parameter out of range
• Wrong parameters in EEPROM
• A/D converter defective
• Short circuit at sensor signal
• Missing sensor (brocken wire, disconnected cable)
• Defective erase roller
00940 Magnetencoding write Error
• Coding Error: Character not possible (see Chapter "4. Appendix –
Characterset for Magnet encoder")
00941 Magnet encoding read Error
• Decoding Error
Programmers Manual Page 26 / 53