User manual

CLEARjet GmbH CX-one
ERROR code <ESC>$E
Description
Use this command to read the ERROR code if printer is in
ERROR mode.
The table below will help you to find the fault.
ASCII – Code
<ESC>$E
HEX – Code
1B 24 45
Return-Parameter
from printer
Error code: 5 Byte ASCII
Example
<ESC>$E
Response: 00921
( Printhead defect )
ERROR code List of possible faults
00000 No ERROR – printer OK
00910 Fault during HW check at boot time
• No valid ADC signal
• Main board or printhead-controller board defect
00920 Printhead too hot
• Printhead too hot ---- wait for cool down
• Main board or printhead-controller board defect
• Printhead defect
00921/
00922
Printhead resistance out of range
• Printhead resistance out of range (worn-out or damaged)
• Too many DOT-failures
• Printhead damaged by static stress
• Main board or printhead-controller board defect
00923 No or unknown printhead
• No printhead connected (cable)
• Error at printhead initializing
• Defective EEPROM on printhead
• Defective Controllerboard
00930 Transport timeout
• Card path or motor movement blocked (card got stuck)
• Photosensor defective or interrupted (clean sensor path)
• Transport motor defective
• Main board defective
Programmers Manual Page 25 / 53