User manual

CLEARjet GmbH CX-one
Move-in erase <ESC>$p[n]
Description
Erase operation is done during move-in the card from front.
Card cycle time is shortened because of saving one
transport cycle. Please note, that the printer can’t erase the
first 30% of the card.
This command is useful only if cards are fetched from front
[n] = 0..... disable move in erase
[n] = 1..... enable move in erase
ASCII – Code
<ESC>$p[n]
HEX – Code
1B 24 70 [n]
Example
<ESC>$p1
Result: enable move in erase
erased area
990 400 300 200 100 000
Save bitram <ESC>MS
Description
Save the contents of the Bitram to Flash-memory
Note: In case of 200x200 dpi and 200x300 dpi printdata,
the whole card can be saved to Flash-memory. In case of
200x600 dpi printdata, only the first half of the card can be
saved. Saved bitram data can only be reprinted in the
same resolution.
Note: Power down or a printer reset within 5 sec. after
using this command may cause unpredictable results.
ASCII – Code
<ESC>MS
HEX – Code
1B 4D 53
Restore bitram <ESC>MR
Description
Restore the contents of the Bitram from Flash-memory
ASCII – Code
<ESC>MR
HEX – Code
1B 4D 52
Programmers Manual Page 19 / 53