User manual

CLEARjet GmbH CX-one
Disable erase roller heating permanent <ESC>%L[n]
Description
Use this command to activate or deactivate the eraser-
roller heating permanent. In deactivated state the erase-
roller heating is stopped and no heat-up will be done.
Use parameter 1 to reactivate erase-roller heating.
Parameter is stored to EEPROM.
[n]=0: disable eraser roller heating permanent
[n]=1: enable eraser roller heating (default)
Note:
When reactivating erase-roller heating perform a printer
reset after using the command!
The erase-roller needs several minutes to cool down!
Power down or a printer reset within 5 sec. after using this
command may cause unpredictable results.
ASCII – Code
<ESC>%L[n]
HEX – Code
1B 25 4C [n]
Example
<ESC>%L0
diable erase-roller heating permanent
Paperticket mode <ESC>P
Description
Print paper ticket ( No erase operation )
This mode is active only for the following card!
ASCII – Code
<ESC>P
HEX – Code
1B 50
Programmers Manual Page 18 / 53