User manual

CLEARjet GmbH CX-one
Set printer resolution <ESC>i[c]
Description
This command sets the resolution of your printer
in y-direction.
[c]=0 200 dpi
[c]=1 300 dpi (default)
[c]=2 not in use
[c]=3 not in use
[c]=4 600 dpi
Note: All settings other than [c]=1 (300 dpi) are active for
one card only. For the next card the printer automatically
returns to the default of 300 dpi.
The resolution in x-direction is 200 or 300dpi, depending
on the printhead actually used.
ASCII – Code
<ESC>i[c]
HEX – Code
1B 69 [c]
Example
<ESC> i4 set resolution 600 dpi in y-direction
Disable eraser roller heating <ESC>Q[n]
Description
Use this command to activate or deactivate the eraser-
roller heating. In deactivated state the erase-roller heating
is stopped.
Use parameter 1 to reactivate erase-roller heating.
[n]=0: disable eraser roller heating
[n]=1: enable eraser roller heating (default)
Note:
The erase-roller needs several minutes to cool down!
Set parameter is active until next reset or power on/off
ASCII – Code
<ESC>Q[n]
HEX – Code
1B 51 [n]
Example
<ESC>Q0
disable erase-roller heating
Programmers Manual Page 17 / 53