User manual

CLEARjet GmbH CX-one
Printenergy offset <ESC>$Op[c] [nnn]
Description
This offset is used to adjust the printenergy. The offset
value is added to the DIP-switch setting.
Use <ESC>Ms command to store the offset-value to the
memory for permanent use.
[c][nnn].... Offset value -100 to +200
Note: Power down or a printer reset within 5 sec. after
using this command may cause unpredictable results.
ASCII – Code
<ESC>$Op[c] [nnn]
HEX – Code
1B 24 4F 70 [c] [nnn]
Example
ESC>$Op–010
decrease print energy by 10 units
to check saved parameters use <ESC>Ml command:
examples:
Erase temperature: <ESC> Ml 08
Response: +00005
Printenergy: <ESC> Ml 09
Response: - 00010
Erase temperature offset <ESC>$Ol[c] [nnn]
Description
This offset is used to adjust the erasing temperature. The
offset value is added to the DIP switch setting.
Use <ESC>Ms command to store the offset-value to the
memory for permanent use.
[c][nnn].... Offset value -200 to +200
( 10 bit represents approx. 1% variation in temperature )
Note: Power down or a printer reset within 5 sec. after
using this command may cause unpredictable results.
ASCII – Code
<ESC>$Ol[c] [nnn]
HEX – Code
1B 24 4F 6C [c] [nnn]
Example
<ESC>$Ol+005
increase erasing temperature by 0,5 %
Programmers Manual Page 16 / 53