User manual

CLEARjet GmbH CX-one
1.4.3 List of tested functions which can be used prior to Windows driver
execution
The correct function of the Windows driver in combination with the ESC-commands
listed below is tested carefully.
Use of commands not listed is not recommended and may cause unpredictable
results.
Command Parameter Description
<ESC>1 - Enable printer
<ESC>2 - Disable printer
<ESC>i [c] Set printer resolution
<ESC>Q [n] Disable eraser roller heating
<ESC>%L [n] Disable erase roller heating permanent
<ESC>P - Paperticket mode
<ESC>%O [n] Read counters and S/N
<SUB> - Brief status
<ESC>A [n] Printhead status
<ESC>a - Firmware code
<ESC>$E - ERROR code
<ESC>x [nn] Print position x-coordinate
<ESC>y [nnn] Print position y-coordinate
<ESC>d [nnn] [mmm] Limit print area
<ESC>e [nnn] [mmm] Limit erase area
<ESC>%p - Get print area
<ESC>%l - Get erase area
<ESC>o [c] [nnn] Shift print area
<ESC>j [hh] Microstep forward
<ESC>k [hh] Microstep backward
<ESC>8 - Auxiliary mode ON
<ESC>7PRINTER - Auxiliary mode OFF
<ESC>6 - Transparent mode ON
<ESC>7PRINTER - Transparent mode OFF
<ESC>c - Get card from hopper
<ESC># - Read direction detector
<ESC>%b - Read barcode
<ESC>$Mr1 [n] Read magnetcode ISO
<ESC>$Mr2 [n] Read magnetcode JIS I
<ESC>$Mr31 Read magnetcode JIS II
<ESC>$Mw1 [n][mmm]{DATA} Write magnetcode ISO
<ESC>$Mw2 [n][mmm]{DATA} Write magnetcode JIS I
<ESC>$Mw31 [mmm]{DATA} Write magnetcode JIS II
<ESC>$m [n] Auto read
If you need functions not listed in this table please use the CLEARjet Active CX SDK.
CLEARjet Active CX SDK includes all functions for encoding of magstripe cards and
smart cards, printing of all Windows fonts, photos and graphics. In addition numerous
control functions to perform all other device functionality are included as well.
Programmers Manual Page 10 / 53