Installation Guide

4
WORKSTATION
2 | ASSEMBLE WORKSTATION FRAME
Attach legs with motor and arm brackets to the center beam using
screws (A).
Note: Replace the default arm brackets if workstation requires BHA19 or
T-brackets. Surface width 36"-47" will need to replace the beam, without
the control box, with BOOST replacement beam (BHANABEAM).
3 | PLACE FRAME ON THE SURFACE
Loosen existing locking screws on adjustable beam to extend beam to fit table
size. Run cord through cutout from the adjustable beam and secure the
handset to control box. Attach the short extension cord to the motor closest
to control box and attach the longer extension cord on the opposite end.
Short Ext. Cord
Long Ext. Cord
Locking Screws
BHANABEAM
BHA19